Skip to tool

Flat lay backdrop size calculator

Measure your arrangement, add the space you want around it and choose a crop. Check whether your backdrop covers the shot, including when turned sideways.

Check my backdrop
An overhead product photograph of a fictional HALEN ceramic set: nested speckled bowls, a plate and a cup on pale linen. No promotional copy. Fictional product, not a customer case.
HALEN ceramic set concept. Measure the outside edges of the entire arrangement, including the cup.

Minimum backdrop: 440 × 550 mm

MeasurementWidth (mm)Height (mm)Fit or purpose
Arrangement with edge space440340Includes all four margins
Minimum backdrop4405504:5 crop, rounded up to whole mm
Board as placed600450Short by 0 mm across, 100 mm vertically
Board turned 90°450600Fits
An overhead product-angle photograph of a fictional TAILO sneaker, looking straight down at the laces and rust-suede toe. Fictional product, not a customer case.
TAILO sneaker concept seen from overhead. The toe and heel both count when measuring the footprint.

Will a 600 × 450 mm board cover a portrait flat lay?

A bowl and spoon arranged across 400 × 300 mm need 440 × 340 mm with 20 mm clear on every edge. A 4:5 portrait crop that keeps all 440 mm of width takes in 550 mm of height. The board is 100 mm too short in its original orientation.

Turn just the board a quarter turn. Its usable area becomes 450 × 600 mm, leaving 10 mm across and 50 mm vertically beyond the frame. Mark the frame corners before positioning the camera.

One arrangement, three different frame sizes

Each example uses the same 400 × 300 mm arrangement, a 20 mm minimum border and a 600 × 450 mm usable board.

Final cropMinimum board areaBoard position
Square · 1:1440 × 440 mmFits as placed
Portrait · 4:5440 × 550 mmTurn the board 90°
Wide · 16:9605 × 340 mmToo narrow in either position

Mark the frame on the actual board

  1. Measure the footprint

    Arrange the products and props. Measure the widest and tallest spans in the same direction as the finished image. Include any shadow you want to keep.

  2. Set the crop and clearance

    Enter the smallest clear border you want on each edge. The narrower side of the arrangement may gain extra space when the frame expands to your chosen ratio.

  3. Check and mark

    Measure only the usable part of the board. Download the measurements and mark the proposed corners with removable tabs just outside the frame. Check through the camera before shooting.

Frequently asked questions

What does turning the board change?

The test swaps the two board dimensions while the products, camera and delivered image keep their orientation. Check whether rotating a directional grain or printed pattern is acceptable.

Do I enter centimetres or millimetres?

Use whole millimetres throughout. For example, enter 400 for 40 cm. Fractional minimum frame dimensions round up to the next millimetre of usable surface.

How should I allow for uneven edges?

Measure the clean rectangle inside any seams or damaged edges. Use this as the board size. Enter the desired visible border separately.

Does this work for an angled shot or a sweep?

The calculation assumes a flat arrangement and a camera looking straight down with its sensor parallel to the board. For tall products, a curved sweep or an oblique camera angle, inspect the edges through the actual camera.