Skip to tool

Storyboard timing calculator

Turn storyboard beat durations into frame ranges for an edit. Download the in-frame, out-frame and length for every shot.

Calculate shot frames
A still of golden olive oil mid-pour from a fictional NARRA green-glass bottle into a stone dish. This is a still used to start a short video, not a finished video, and not a customer case.
NARRA pouring still. Use the moment the oil hits the dish as a beat boundary.

108 frames · 24 fps

BeatIn (inclusive)Out (exclusive)Frames
Reveal03030
Demonstration309060
End card9010818
A still of a fictional NARRA olive-oil bottle on a Mediterranean table with bread, oil and olives. A starting still for a short video, not a finished video, and not a customer case.
A closing product still gives the editor a place to test the final hold and read the action line.

Which frame starts the end card?

At 24 fps, a 1.25-second reveal takes 30 frames and a 2.5-second demonstration takes 60. The end card starts on frame 90. A further 0.75 seconds finishes at boundary 108, so the final visible frame is 107. Each out-point in the sheet is exclusive.

Match the integer frame rate in your editor. The sheet rounds cumulative boundaries to the nearest frame, which keeps rounding from drifting across a sequence.

Read the 24 fps edit sheet

The end card gets 18 visible frames in this example. If a fade uses six of them, the fully revealed hold lasts only 12 frames, or half a second.

BeatDurationVisible framesNext cut
Reveal1.25 s0–2930
Demonstration2.50 s30–8990
End card0.75 s90–107108

Move from seconds to an edit list

  1. Choose the timeline rate

    Use the integer frame rate of the edit sequence. Take this from the project settings before converting your written beat lengths.

  2. Time one action per beat

    Enter the beat name, a vertical bar and its duration in seconds. Give the reveal, demonstration and closing hold separate rows so a timing change stays easy to review.

  3. Set the edit boundaries

    Download the frame list and place cuts at the inclusive in-points. Play it once at normal speed on the intended screen. Time the closing line from the moment it becomes fully legible.

Frequently asked questions

Is the out-frame included in the shot?

The out-point is the boundary where the following beat starts. A shot with in-point 30 and out-point 90 displays frames 30 through 89, for a total of 60 frames.

How does the tool handle fractional frames?

It rounds the cumulative elapsed time at each cut. At 24 fps, three beats of 0.1 seconds yield lengths of two, three and two frames. Each new shot starts where the preceding one ends.

Why does a short beat show an error?

If the proposed cut rounds to the same frame as the preceding cut, the beat would have no visible frame. Increase its duration or combine it with an adjacent beat.

Can I use 23.976 or drop-frame timecode?

The supported rates are 24, 25, 30, 50 and 60 fps. The CSV gives integer frame boundaries. For fractional rates or drop-frame timecode, use the corresponding timeline settings in your editor.